Commander 2WD V8-4.7L VIN P Flex Fuel (2007)
7. Reinstall the trim onto the quarter inner panel.
8. Route the seat belt lower anchor (6) through the seat belt opening in the upper C-pillar trim (3).
9. Reinstall the trim onto the upper C-pillar.
10. Engage the seat belt lower anchor under the loosened screw (9) that secures the seat latch striker bracket (8) to the rear floor panel. Be certain the
seat belt webbing between the turning loop and the lower anchor is not twisted.
11. Tighten the screw that secures the lower anchor and the seat latch striker bracket to the rear floor panel. Tighten the screw to 50 Nm (37 ft. lbs.).
12. Restore the second row outboard seat to its seating position.
Third Row
THIRD ROW
WARNING: To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts,
buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt that is cut,
frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or ineffective buckle or
retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child restraint anchor or the unit to which the
anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or child restraint component. Always replace damaged or
ineffective seat belt and child restraint components with the correct, new and unused replacement parts listed in the DaimlerChrysler
Mopar(R) Parts Catalog.
1. Position the third row seat belt and retractor as a unit through the top of the pocket on the front upper outboard corner of the seat back frame. Be
certain to engage the tab on the retractor into the slot within the pocket.
2. Install and tighten the screw (3) below the pull strap (1) from the back of the seat back frame (2) that secures the retractor. Tighten the screw to 43
Nm (32 ft. lbs.).
3. Position the retractor retainer bracket (2) over the top of the retractor pocket (4) on the front upper outboard corner of the seat back frame (3).
4. Install and tighten the through bolt (1) that secures the retainer bracket to the top of the retractor pocket on the seat back frame. Tighten the bolt to
43 Nm (32 ft. lbs.).
