Commander 2WD V8-4.7L VIN P Flex Fuel (2007)
5. Reinstall the trim onto the top and the back of the third row seat back frame.
6. Slide the seat belt webbing (2) through the slot (3) in the seat belt escutcheon (1) and position the escutcheon to the top of the third row seat back
(5).
7. Install and tighten the two screws (4) that secure the escutcheon to the top of the seat back. Tighten the screws to 3 Nm (28 in. lbs.).
8. Position the seat belt lower anchor (4) to the outboard rear corner of the third row seat support bracket (1). Be certain that the belt webbing is not
twisted between the top of the seat back and the lower anchor.
9. Install and tighten the screw (5) that secures the lower anchor to the seat support bracket. Tighten the screw to 43 Nm (32 ft. lbs.).
10. Reinstall the third row seat into the vehicle.
