Commander 2WD V8-4.7L VIN P Flex Fuel (2007)
1. Position the upper instrument panel switch pod (2) to the back of the center bezel (1).
2. Install and tighten the four screws (3) that secure the upper switch pod to the center bezel. Tighten the screws to 2 Nm (17 in. lbs.).
3. Install the four upper instrument panel switch pod (3) fasteners.
4. Reconnect the wire harness connector to the back of the upper switch pod.
5. Reinstall the center bezel onto the instrument panel.
6. Reconnect the battery negative cable.
