Commander 2WD V8-4.7L VIN P Flex Fuel (2007)
Tie Rod End: Service and Repair
Removal - Outer Tie Rod End
REMOVAL - OUTER TIE ROD END
NOTE: Do not twist the boot anytime during removal or installation.
1. Loosen the jam nut (3).
2. Remove the outer tie rod end (2) nut (1) from the ball stud.
3. Separate the outer tie rod end (3) from the knuckle with Remover 8677 Puller (5).
4. Unthread the outer tie rod end (3) from the inner tie rod (1). Count the number of turns when removing the tie rod end, This will give a good
starting point when reassembling and toe adjustment.