Commander 2WD V8-4.7L VIN P Flex Fuel (2007)
13. Install the electrohydraulic control module (12) onto the shift plate (13).
14. Bend the retaining lug on stiffening rib on transmission oil temperature sensor to retain the electrohydraulic control module.
15. Install the solenoid valves (6 - 11) into shift plate (13).
NOTE: Check O-rings on solenoid valves for damage and replace if necessary.
16. Install the leaf springs (5).
17. Install the Torx(R) socket bolts (3, 4). Tighten the bolts to 8 Nm (71 in.lbs.).
NOTE: Pay attention to the different lengths of the Torx(R) socket bolts.
18. Install the solenoid caps (1, 2).
19. Install the electrohydraulic unit into the vehicle.
