Commander 2WD V8-5.7L (2008)
Keyless Start Antenna: Service and Repair
Removal
REMOVAL
The Remote Start Antenna Module Assembly consists of an electrical connection to the WCM/SKREEM (1), a length of coax cable (2), mounting clips
or tie wraps (3) and (4), and a control module/antenna (5).
The control module (1) is located behind and to the left side of the glove box opening (3). The module electrical connector plugs into the
WCM/SKREEM attached to the ignition switch located near the right side of the steering column.
1. Disconnect and isolate negative cable from battery.
2. Remove glovebox. Refer to Glove Box Assembly Removal.
3. Remove radio to gain access to coax cable tie wraps. Refer to Radio Removal.
