Commander 2WD V8-5.7L (2008)
Trailer Lamps: Service and Repair
Trailer Tow Module
Removal
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Fold and tumble the right outboard second row seat assembly forward.
3. Remove the carpeted cover panel from over the cavity on the right outboard end of the intermediate step assembly (4).
4. Disconnect the four body wire harness connectors from the connector receptacles (2) on the back of the Trailer Module (TM) (3).
5. Remove the two nuts (6) that secure the TM to the studs on the mounting plate (5) on the floor of the step cavity.
6. Remove the module from the mounting plate.
Installation
INSTALLATION
1. Position the Trailer Module (TM) (3) over the two studs integral to the mounting plate (5) on the floor of the right cavity of the intermediate step
assembly (4).
2. Install and tighten the two nuts (6) that secure the module to the mounting plate studs. Tighten the nuts to 1 Nm (15 in. lbs.).
3. Reconnect the four body wire harness connectors to the module connector receptacles (2).
4. Reinstall the carpeted cover panel over the cavity on the right outboard end of the intermediate step assembly.
5. Restore the right outboard second row seat assembly to its normal seating position.
6. Reconnect the battery negative cable.
