Commander 2WD V8-5.7L (2008)
Trunk / Liftgate Latch: Service and Repair
Liftgate Glass Latch - Installation
INSTALLATION
NOTE: Grand Cherokee (WK) shown, Commander (XK) similar.
1. Position the latch (3) into the inside of the liftgate and align using the marks made during removal.
2. Install and tighten the three bolts (2). Tighten the bolts to 12 Nm (9 ft. lbs.).
3. Connect electrical connectors (1) to the latch (3).
4. Check and adjust the glass position, if necessary.
5. Install the trim panel. See: Trunk / Liftgate Interior Trim Panel/Service and Repair/Liftgate Trim Panel - Installation
6. Connect the battery negative cable.
