Commander 2WD V8-5.7L (2008)
4. Install a new trim plug (1) into the trim panel.
5. Engage the seat belt lower anchor (2) under the loosened bolt (3) that secures the seat latch striker bracket to the rear floor panel. Be certain the
seat belt webbing between the turning loop and the lower anchor is not twisted.
6. Tighten the bolt that secures the lower anchor (2) and the seat latch striker bracket to the rear floor panel. Tighten the screw to 50 Nm (37 ft. lbs.).
7. Restore the second row outboard seat to its seating position.
Removal
REMOVAL
1. Remove the rear header molding, See: Header Molding - Removal