Commander 2WD V8-5.7L (2008)
Brake Pad: Service and Repair
Brake Pads - Installation
Front
FRONT
1. Remove and clean all rust and debris from the anti-rattle clip mounting surfaces (3) on the brake caliper adapter (2).
2. Install new anti-rattle clips (3) into the caliper adapter (2).
3. Install the inboard and outboard brake pads (4) onto the caliper adapter (2).
4. Install caliper (5) on the caliper adapter (2).
5. Install the caliper slide pin bolts (2) and tighten to 44 Nm (32 ft. lbs.).
6. Install wheel and tire assembly.
7. Remove support and lower vehicle.
8. Pump brake pedal until caliper pistons and brake pads are seated and a firm brake pedal is obtained.
9. Fill brake fluid.
Rear
REAR
