Commander 2WD V8-5.7L (2008)
Hydraulic Control Assembly - Antilock Brakes: Service and Repair
Hydraulic Control unit (HCU) - Installation
INSTALLATION
NOTE: If the ABM is being replaced with a new ABM is must be reprogrammed with the use of a scan tool.
1. Install the 3 ABM (1) mounting bolts to the HCU (2) if removed tighten mounting bolts to 12 Nm (9 ft. lbs.).
2. Install the HCU (3) with bracket (5) to the vehicle and tighten the 2 mounting nuts.
3. Install the 4 chassis lines (3) at the HCU (4).
4. Install the secondary brake line at the HCU (4).