Commander 2WD V8-5.7L (2008)
9.
Remove the three screws (1) that secure the blend door actuator (2) to the right side of the HVAC air distribution housing (3).
10. Remove the blend door actuator from the air distribution housing and disconnect the HVAC wire harness connector (4) from the actuator.
11. Remove the blend door actuator from the vehicle.
Rear Controls
REMOVAL
1. Remove rear HVAC housing (1) and place it on a workbench .
2. Disconnect the rear HVAC wire harness connector (2) from the rear blend door actuator (3).
3. Remove the two screws (4) that secure the rear blend door actuator to the back of the rear HVAC housing and remove the actuator.
