Commander 2WD V8-5.7L (2008)
Air Door Actuator / Motor: Service and Repair
Mode Door Actuator - Installation
Front Controls
INSTALLATION
PANEL/DEFROST/DEMIST/FLOOR
1. Position the mode door actuator (1) into the vehicle.
2. Install the mode door actuator onto the left side of the HVAC air distribution housing (2). If necessary, rotate the actuator slightly to align the
splines on the actuator output shaft (3) with those on the mode door cam (4).
3. Install the screws (1) that secure the mode door actuator (2) to the left side of the air distribution housing (3). Tighten the screws to 2 Nm (17 in.
lbs.).
4. Connect the HVAC wire harness connector (4) to the mode door actuator.
5. Install the instrument panel silencer onto the driver side of the instrument panel.
6. Reconnect the negative battery cable.
2nd ROW/CONSOLE
