Commander 2WD V8-5.7L (2008)
1. Disconnect and isolate the negative battery cable.
2. Remove the glove box from the instrument panel See: Body and Frame/Interior Moulding / Trim/Glove Compartment/Service and
Repair/Instrument Panel Glove Box - Removal.
3. Disconnect the HVAC wire harness connector (1) from the recirculation door actuator (2).
4. Remove the three screws (4) that secure the recirculation door actuator to the HVAC air inlet housing (3) and remove the actuator.
Recirculation Door Actuator - Installation
INSTALLATION
1. Position the recirculation door actuator (1) into the vehicle.
2. Install the recirculation door actuator onto the HVAC air inlet housing (2). If necessary, rotate the actuator slightly to align the splines on the
actuator output shaft (3) with those on the recirculation door pivot shaft (4).