Commander 2WD V8-5.7L (2008)
6. Reconnect the battery negative cable.
Bulb - Second Row
BULB - SECOND ROW
CAUTION: Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the
lamp, the socket or the lamp wiring.
NOTE: The second row reading lamps are integral to the grab handle in the headliner on the inner roof side rail over each outboard second
row seating position.
1. Align the base of the bulb (1) with the bulb holder within the reading lamp housing.
2. Push the bulb into the holder until the base is fully seated.
3. Insert the large tab on the rear end of the lamp lens (1) into the rear of the lamp housing.
4. Using hand pressure, push the small tab at the upper front corner of the lens (2) rearward and inward towards the lamp housing until it snaps into
place.
5. Reconnect the battery negative cable.
Bulb - Rear
BULB - REAR
CAUTION: Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the
lamp, the socket or the lamp wiring.
