Commander 2WD V8-5.7L (2008)
Marker Lamp: Service and Repair
Front Lamp Unit - Installation
LAMP
1. Check to be certain that the three front lamp unit plastic nuts (1) are properly installed and in good condition.
2. Position the lamp close enough to the front of the vehicle to reconnect the headlamp and dash wire harness connector to the pigtail connector on
the back of the lamp housing.
3. Position the lamp to the front of the vehicle.
4. Install the push pin fastener (3) that secures the upper outboard lamp mounting bracket to the top of the radiator yoke hydroform.
5. Install and tighten the three screws (2) that secure the two lower and the upper inboard lamp mounting brackets to the front end sheet metal.
Tighten the screws to 3 Nm (23 in. lbs.).
6. If the engine fresh air intake tube was removed during lamp removal, position it between the lamp and the radiator yoke hydroform and snap it into
the air cleaner housing.
7. Reinstall the fascia onto the front of the vehicle. See: Body and Frame/Bumper/Front Bumper/Front Bumper Cover / Fascia/Service and
Repair/Front Fascia - Installation.
8. Reinstall the grille onto the front of the vehicle. See: Body and Frame/Grille/Service and Repair/Grille - Installation.
9. Reinstall the front lamp unit cover over the top of the lamp. See: Service and Repair/Removal and Replacement/Front Lamp Unit - Installation.
10. Reconnect the battery negative cable.
11. Confirm proper headlamp alignment. See: Service and Repair/Procedures/Front Lamp Aiming.
