jeep Workshop Repair Guides

Jeep Workshop Service and Repair Manuals

Procedures|Page 1865 > < Procedures|Page 1863
Page 3
background image

10. Install plugs in, or tape over the opened liquid and suction line fittings and the receiver/drier and expansion valve ports.
11. Remove the A/C liquid line from the engine compartment.

Rear Plumbing

REMOVAL

WARNING: Refer to the applicable warnings and cautions for this system before performing the following operation See: Heating and Air
Conditioning/Service Precautions/Warning and See: Heating and Air Conditioning/Service Precautions/Caution. Failure to follow the warnings
and cautions could result in possible personal injury or death.

NOTE: 4.7L engine shown. Other engines similar.

1. Disconnect and isolate the negative battery cable.
2. Recover the refrigerant from the refrigerant system See: Heating and Air Conditioning/Service and Repair/Refrigerant System Recovery.
3. Raise and support the vehicle.
4. Remove the nut (4) that secures the tapping block of the liquid line extension tube (6) to the underbody liquid line (5).
5. Disconnect the liquid line extension tube from the underbody liquid line and remove and discard the O-ring seal.
6. Lower the vehicle.
7. Disconnect the A/C liquid line (1) from the front A/C expansion valve (2) and the receiver/drier (3) and remove the A/C liquid line from the

engine compartment See: A/C Line - Removal.

8. Install plugs in, or tape over the opened refrigerant line fittings and expansion valve and receiver/drier ports.

Front Plumbing - 5.7L Engine

5.7L ENGINE

WARNING: Refer to the applicable warnings and cautions for this system before performing the following operation See: Heating and Air
Conditioning/Service Precautions/Warning and See: Heating and Air Conditioning/Service Precautions/Caution. Failure to follow the warnings
and cautions could result in possible personal injury or death.

1. Disconnect and isolate the negative battery cable.
2. Recover the refrigerant from the refrigerant system See: Heating and Air Conditioning/Service and Repair/Refrigerant System Recovery.
3. Remove the air intake tube and the resonator .See: Filters/Air Cleaner Housing/Service and Repair/Air Intake System - Removal

Procedures|Page 1865 > < Procedures|Page 1863