Commander 2WD V8-5.7L (2008)
Camshaft Position Sensor: Service and Repair
Camshaft Position Sensor - Removal
5.7L/6.1L
The Camshaft Position Sensor (CMP) (1) is located on right side of timing gear/chain cover (2) near engine thermostat housing.
1. Disconnect air resonator clamps at throttle body and also at air filter housing. Remove air resonator.
2. Disconnect electrical connector (4) at CMP sensor.
3. Remove sensor mounting bolt (3).
4. Carefully twist sensor (2) from timing gear/chain cover (1).
5. Check condition of sensor O-ring.
