Commander 2WD V8-5.7L (2008)
3. Carefully install the full open switch wire harness routing clips (2) into the power liftgate drive unit assembly (1).
4. Insert the full open switch wire terminals (2) into the liftgate drive unit connector (1) ensuring the proper terminal location as noted in the full open
switch removal procedure.
5. Install the power liftgate drive unit assembly on the vehicle, See: Body and Frame/Doors, Hood and Trunk/Trunk / Liftgate/Trunk / Liftgate
Motor/Service and Repair/Power Liftgate Drive Unit - Installation.
6. Connect the battery negative cable.
7. Using an appropriate scan tool, check and erase any power liftgate control module diagnostic trouble codes.
8. Perform the power liftgate learn cycle, See: Body and Frame/Doors, Hood and Trunk/Trunk / Liftgate/Service and Repair/Procedures/Power
Liftgate Learn Cycle.
9. Verify power liftgate system operation.