Commander 2WD V8-5.7L (2008)
Crankshaft Position Sensor: Service and Repair
Crankshaft Position Sensor - Removal
5.7L
The Crankshaft Position (CKP) sensor (4) is located at the right-rear side of the engine cylinder block (1). It is positioned and bolted into a machined
hole in the engine block.
1. Raise vehicle.
2. Disconnect CKP electrical connector (2) at sensor.
3. Remove CKP mounting bolt (3).
4. Carefully twist sensor from cylinder block.
5. Remove sensor from vehicle.
6. Check condition of sensor o-ring.
