Commander 2WD V8-5.7L (2008)
10. Install the battery wire harness retaining clips (2) to the valve cover studs.
11. On 5.7L engines, reconnect the battery wire harness connector (6) to the generator field terminal connector receptacle on the back of the generator.
12. Install the generator output cable eyelet terminal (4) onto the generator output terminal stud.
13. Install and tighten the nut (5) that secures the generator output cable eyelet terminal (4) to the generator output terminal stud. Tighten the nut to 14
Nm (125 in. lbs.).
14. On 3.7L and 4.7L engines, reconnect the battery wire harness connector (8) to the generator field terminal connector receptacle on the back of the
generator.
15. Install the generator output cable eyelet terminal (7) onto the generator output terminal stud.
16. Install and tighten the nut (6) that secures the generator output cable eyelet terminal (7) to the generator output terminal stud. Tighten the nut to 14
Nm (125 in. lbs.).
17. Install the battery wire harness retaining clip (9) onto the valve cover stud.
18. Install the battery wire harness three pin connector (11) onto the battery tray (12).
19. Connect the battery wire harness three pin connector (11).
