Commander 2WD V8-5.7L (2008)
5. Remove the o-ring (2) and discard then remove disc brake rotor (1). See: Brakes and Traction Control/Disc Brake System/Brake
Rotor/Disc/Service and Repair/Removal and Replacement/Brake Rotor - Removal.
6. Remove the wheel speed sensor bolt (2) and disconnect the wire from the retaining clips from the knuckle See: Brakes and Traction
Control/Antilock Brakes / Traction Control Systems/Wheel Speed Sensor/Service and Repair/Front Wheel Speed Sensor - Removal.
7. Remove the axle shaft nut. (if equipped with four wheel drive)
8. Remove the hub/bearing (3). See: Wheel Bearing/Service and Repair/Front Hub / Bearing - Removal.
9. Remove the outer tie rod end retaining nut.
10. Separate the outer tie rod end (3) from the steering knuckle using special tool 8677(5). See: Steering/Tie Rod/Tie Rod End/Service and Repair/Tie
Rod End - Removal.
