Commander 2WD V8-5.7L VIN 2 (2006)
Thermostat: Service and Repair
THERMOSTAT
REMOVAL
5.7L
WARNING: Do not loosen the radiator draincock with the cooling system hot and pressurized. Serious burns from the coolant can occur.
Do not waste reusable coolant. If the solution is clean, drain the coolant into a clean container for reuse.
If the thermostat is being replaced, be sure that the replacement is the specified thermostat for the vehicle model and engine type.
1. Disconnect the negative battery cable.
2. Drain the cooling system
3. Remove the radiator hose clamp and radiator hose at the thermostat housing (1).
4. Remove the thermostat housing mounting bolts (2), thermostat housing (1) and thermostat.
INSTALLATION
1. Position the thermostat and housing (2) on the front cover.
2. Install thermostat housing bolts (1). Tighten the bolts (1) to 13 Nm (112 inch lbs.).
3. Install the radiator hose (4) onto the thermostat housing (2).
4. Fill the cooling system.
5. Connect negative battery cable.
6. Start and warm the engine. Check for leaks.
