Commander 2WD V8-5.7L VIN 2 (2006)
Valve Deactivation Solenoid: Service and Repair
SOLENOID-MDS
REMOVAL
1. Disconnect the negative battery cable.
2. Remove the intake manifold.
3. Remove wiring harness connectors from the MDS solenoids.
4. Remove hold down bolt from MDS solenoid.
5. Remove MDS solenoid.
INSTALLATION
1. Verify that MDS bores are free of debris, before solenoid installation.
2. Install MDS solenoid fully into block.
3. Install hold down bolt and torque to 11 Nm (97 inch lbs.).
4. Reconnect the MDS wiring harness to the solenoids.
5. Install the intake manifold.
