Commander 2WD V8-5.7L VIN 2 (2006)
Control Assembly: Service and Repair
Rear
CONTROL-A/C-HEATER
REMOVAL
1. Disconnect and isolate the negative battery cable.
2. Using trim stick C-4755 or equivalent (1), remove the rear A/C-heater control (2) from the bezel (3) located on the right interior quarter trim panel
(4), by releasing the retainer clips from the trim panel.
3. Disconnect the wire harness connectors from the rear A/C-heater control and remove the control from the vehicle.
INSTALLATION
1. Position the rear A/C-heater control (1) near the bezel (3) located in the right interior quarter trim panel (4).
2. Connect the wire harness connectors to the back of the rear A/C-heater control.
3. Install the rear A/C-heater control into the bezel and gently push down on the control until the retainer clips (2) fully engage the slots in the bezel.
4. Reconnect the negative battery cable.
5. Initiate the Actuator Calibration function using a scan tool. Refer to HVAC System Test.
