Commander 2WD V8-5.7L VIN 2 (2006)
Air Filter Element: Service and Repair
Filter Element Only
REMOVAL
NOTE: Always unplug the Charge Air Temperature sensor before removing the resonator.
Housing removal is not necessary for element (filter) replacement.
1. Loosen clamp (1) and disconnect air duct (2) at air cleaner cover.
2. Pry over 4 spring clips (5) from housing cover (3) (spring clips retain cover to housing).
3. Release housing cover from locating tabs on housing and remove cover.
4. Remove air cleaner element (filter) from housing.
5. Clean inside of housing before replacing element.
Housing Assembly
NOTE: Always unplug the Charge Air Temperature sensor before removing the resonator.
1. Loosen clamp and disconnect air duct at air cleaner cover.
2. Lift entire housing assembly (1)from 4 locating pins (2).
INSTALLATION
1. Install filter element into housing.
2. Position housing cover into housing locating tabs.