Commander 4WD V6-3.7L VIN K (2007)
Alarm Horn: Service and Repair
Removal
Bracket
BRACKET
1. Remove the alarm siren module and bracket as a unit from within the hollow on the back of the right end of the front frame crossmember outboard
of the right frame rail.
2. Remove the screw (3) that secures the bracket (2) to the back of the siren (1).
3. Remove the siren from the bracket.
Siren
SIREN
1. Disconnect and isolate the battery negative cable.
2. Raise and support the vehicle.
3. Remove the horn(s) and mounting bracket from the outboard side of the right front frame rail.
4. Locate the alarm siren module (2) within the hollow on the back of the right end of the front frame crossmember (1) outboard of the right frame
rail.
5. Disconnect the headlamp and dash wire harness connector from the connector receptacle near the top of the siren.
6. Remove the screw (3) that secures the siren mounting bracket (4) to the right end of the front crossmember.
