Commander 4WD V6-3.7L VIN K (2007)
2. With the display lens held flush against the face of the headliner, position the molded plastic retainer (3) over the display housing and flush against
the headliner substrate.
3. Slide the retainer toward the right side of the vehicle to lock the display into place.
4. Reconnect the wire harness connector (1) to the connector receptacle on the left end of the display housing.
5. Reinstall the trim onto both upper D-pillars.
6. Reinstall the trim onto the upper liftgate opening.
7. Reconnect the battery negative cable.
