Commander 4WD V6-3.7L VIN K (2007)
Trailer Lighting Module: Service and Repair
Removal
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Fold and tumble the right outboard second row seat assembly forward.
3. Remove the carpeted cover panel from over the cavity on the right outboard end of the intermediate step assembly (4).
4. Disconnect the four body wire harness connectors from the connector receptacles (2) on the back of the Trailer Module (TM) (3).
5. Remove the two nuts (6) that secure the TM to the studs on the mounting plate (5) on the floor of the step cavity.
6. Remove the module from the mounting plate.
