Commander 4WD V6-3.7L VIN K (2007)
Sunroof / Moonroof Motor: Removal and Replacement
Sunroof Motor With Control Unit - Removal
REMOVAL
WARNING: Do not attempt to move or reposition the sunroof glass panel or drive cables with the motor/module removed. Vehicle/sunroof
damage or personal injury may result.
WARNING: The sunroof must first be calibrated and the Motor/Module Initialization Procedure must be completed any time a sunroof
motor/module is replaced with a new component. Failure to perform this procedure could result in vehicle damage and/or personal injury.
1. Disconnect the battery negative cable.
2. Remove the vehicle headliner.
3. Remove the power sunroof motor/module electrical connector (2).
4. Remove the retaining screws (3) and remove the motor/module (1) from the vehicle.
Sunroof Motor With Control Unit - Installation
INSTALLATION
WARNING: Do not attempt to move or reposition the sunroof glass panel or drive cables with the motor/module removed. Vehicle/sunroof
damage or personal injury may result.
WARNING: The sunroof must first be calibrated and the Motor/Module Initialization Procedure must be completed any time a sunroof
motor/module is replaced with a new component. Failure to perform this procedure could result in vehicle damage and/or personal injury.
