Commander 4WD V6-3.7L VIN K (2007)
Brake Caliper: Removal and Replacement
Front
FRONT
1. Raise and support vehicle.
2. Remove front wheel and tire assembly.
3. Drain small amount of fluid from master cylinder brake reservoir with clean suction gun.
4. Bottom caliper pistons into the caliper (5) by prying the caliper over.
5. Remove brake hose banjo bolt and gasket washers (6). Discard gasket washers.
6. Remove the caliper slide bolts (2).
7. Remove the caliper (1) from the adapter (4).
Rear
REAR
1. Raise and support vehicle.
2. Remove rear wheel and tire assembly.
3. Drain small amount of fluid from master cylinder brake reservoir with a clean suction gun.