Commander 4WD V6-3.7L VIN K (2007)
4. Install the HCU (3) with bracket (5) to the vehicle and tighten the 2 mounting nuts.
5. Reconnect the HCU electrical connector (5).
6. Install the 4 chassis lines (3) at the HCU (4).
7. Install the secondary brake tube at the HCU (4).
8. Install the secondary brake tube at the master cylinder.
9. Install the primary brake tube at the HCU (4).
10. Install the primary brake tube at the master cylinder.
11. Install negative battery cable to the battery.
12. Remove the brake pedal prop rod.
13. Bleed base and ABS brake systems.
14. Initialize the ABS module using the scan tool.
