Commander 4WD V6-3.7L VIN K (2007)
21. After installing all chains, it is recommended that the idler gear end play be checked. The end play must be within 0.10 -0.25 mm (0.004 - 0.010
in.). If not within specification, the idler gear (1) must be replaced.
22. Install timing chain cover and crankshaft damper.
23. Install cylinder head covers.
NOTE: Before installing threaded plug in right cylinder head, the plug must be coated with sealant to prevent leaks.
24. Coat the large threaded access plug (2) with Mopar(R) Thread Sealant with Teflon, then install into the right cylinder head and tighten to 81
Nm (60 ft. lbs.).
25. Install the oil fill housing.
26. Install access plug (1) in left cylinder head.
27. Install power steering pump.
28. Fill cooling system.
29. Connect negative cable to battery.
