Commander 4WD V6-3.7L VIN K (2007)
10. Install the screws (1) that secure the blend door actuator (2) to the right side of the air distribution housing (3). Tighten the screws to 2 Nm (17 in.
lbs.).
11. Connect the HVAC wire harness connector (4) to the blend door actuator.
12. On LHD models, install the glove box into the instrument panel.
13. On RHD models, install the instrument panel silencer onto the driver side of the instrument panel.
14. Reconnect the negative battery cable.
Removal
REMOVAL
WARNING: Disable the airbag system before attempting any steering wheel, steering column, or instrument panel component diagnosis or
service. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to discharge before
performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to take the proper precautions could
result in accidental airbag deployment and possible personal injury or death.
NOTE: The heater-A/C system is equipped with two mode door actuators. One for the air doors for the outlets in the instrument panel and one for the
air door for the 2nd row/console outlets.
PANEL/DEFROST/DEMIST/FLOOR
1. Disconnect and isolate the negative battery cable.
2. On LHD models, remove the instrument panel silencer from the driver side of the instrument panel.
3. On RHD models, remove the glove box from the instrument panel.
4. Remove the three screws (1) that secure the mode door actuator (2) to the left side of the HVAC air distribution housing (3).
