Commander 4WD V6-3.7L VIN K (2007)
3. Install the screws (1) that secure the mode door actuator (2) to the left side of the air distribution housing (3). Tighten the screws to 2 Nm (17 in.
lbs.).
4. Connect the HVAC wire harness connector (4) to the mode door actuator.
5. On LHD models, install the instrument panel silencer onto the driver side of the instrument panel.
6. On RHD models, install the glove box into the instrument panel.
7. Reconnect the negative battery cable.
2nd ROW/CONSOLE
8. Position the mode door actuator (1) into the vehicle.
9. Install the mode door actuator onto the rear of the HVAC air distribution housing (2). If necessary, rotate the actuator slightly to align the splines
on the actuator output shaft (3) with those on the pivot shaft of the rear floor/console air door (4).
