Commander 4WD V6-3.7L VIN K (2007)
5. Lubricate a new dual plane seal with clean refrigerant oil and install it onto the front liquid line fitting. Use only the specified seal as it is made of a
special material for the R-134a system. Use only refrigerant oil of the type recommended for the A/C compressor in the vehicle.
6. Connect the A/C liquid line (2) to the A/C receiver/drier (3).
7. Install the nut (1) that secures the A/C liquid line to the A/C receiver/drier. Tighten the nut to 20 Nm (15 ft. lbs.).
NOTE: LHD model with 5.7L engine shown in illustration. RHD model and other engines similar.
8. Lubricate a new O-ring seal with clean refrigerant oil and install it onto the rear suction line fitting. Use only the specified seal as it is made of a
special material for the R-134a system. Use only refrigerant oil of the type recommended for the A/C compressor in the vehicle.
9. Connect the A/C suction line (2) to the A/C expansion valve (1).
10. Install the nut (3) that secures the A/C suction line and the A/C liquid line (10) to the A/C expansion valve. Tighten the nut to 23 Nm (17 ft. lbs.).
11. Install the air cleaner housing, air intake tube and the resonator.
12. Reconnect the negative battery cable.
13. Evacuate the refrigerant system.
14. Adjust the refrigerant oil level.
15. Charge the refrigerant system.
Removal
3.7L/4.7L ENGINES
WARNING: Refer to the applicable warnings and cautions for this system before performing the following operation. Failure to follow the
warnings and cautions could result in possible personal injury or death.
