Commander 4WD V6-3.7L VIN K (2007)
NOTE: LHD model shown. RHD model similar.
1. Remove the HVAC housing assembly.
2. Disconnect the HVAC wire harness (1) from the recirculation door actuator (2).
3. Remove the three screws (3) that secure the air inlet housing (4) to HVAC housing (5).
4. Tilt the rear of the air inlet housing upward to disengage the two tab-and-slot type retainers located at the front of the inlet housing and remove the
inlet housing from the HVAC housing.
NOTE: If the foam seal on the air inlet housing is deformed or damaged, it must be replaced.
5. If required, disassemble the air inlet housing.
Air Inlet Housing Installation - Front
HOUSING-AIR INLET
NOTE: The air inlet housing must be removed from HVAC housing and disassembled for service of the recirculation-air door.
NOTE: LHD model shown. RHD model similar.
1. Position the air distribution housing (4) onto the top of the HVAC housing (5) by inserting the two tabs located at the front of the air inlet housing
into the slots located on the top of the HVAC housing.
2. Tip the air distribution housing downward until it is properly seated on the HVAC housing.
3. Install the three screws (3) that secure the air distribution housing to the HVAC housing. Tighten the screws to 2.2 Nm (20 in. lbs.).
4. Connect the HVAC wire harness (1) to the recirculation door actuator (2).