Commander 4WD V6-3.7L VIN K (2007)
Hazard Warning Switch: Service and Repair
Installation
INSTALLATION
WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the supplemental restraint system before attempting
any steering wheel, steering column, airbag, seat belt tensioner, impact sensor, or instrument panel component diagnosis or service. Disconnect
and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further
diagnosis or service. This is the only sure way to disable the supplemental restraint system. Failure to take the proper precautions could result
in accidental airbag deployment.
1. Position the hazard switch (1) to the back of the Steering Control Module (SCM) (3) and align the switch connector to the receptacle in the SCM.
2. Press the switch into place until both plastic latch features (2) integral to the SCM are fully engaged on the back of the switch housing.
3. Reinstall the upper and lower shrouds onto the steering column.
4. Reconnect the battery negative cable.
