Commander 4WD V6-3.7L VIN K (2007)
Headlamp Alignment Switch: Testing and Inspection
HEADLAMP LEVELING SWITCH
WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the supplemental restraint system before attempting
any steering wheel, steering column, airbag, seat belt tensioner, impact sensor, or instrument panel component diagnosis or service. Disconnect
and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further
diagnosis or service. This is the only sure way to disable the supplemental restraint system. Failure to take the proper precautions could result
in accidental airbag deployment.
1. Disconnect and isolate the battery negative cable.
2. Disconnect the instrument panel wire harness connector from the upper instrument panel switch pod.
3. Using an ohmmeter, perform the resistance tests at the terminal pins in the switch pod connector receptacle as shown in the Headlamp Leveling
Switch Tests table.
4. If the switch fails any of the resistance tests, replace the ineffective upper switch pod as required.
