Commander 4WD V6-3.7L VIN K (2007)
Evaporative Emission Control Canister: Service and Repair
Installation
INSTALLATION
The EVAP canister and ESIM switch are replaced together as one assembly.
1. Position canister (5) into mounting bracket (6). Install and tighten two canister-to-mounting bracket nuts (4).
2. Position canister/switch/bracket assembly to body. Install and tighten three mounting bracket-to-body nuts (1) and (2).
3. Carefully install vapor/vacuum lines to EVAP canister and ESIM switch. The vapor/vacuum lines and hoses must be firmly connected. Check the
vapor/vacuum lines at the EVAP canister, ESIM switch and EVAP canister purge solenoid for damage or leaks. If a leak is present, a Diagnostic
Trouble Code (DTC) may be set.
4. Connect electrical connector to ESIM switch.
5. Install plastic splash shield at rear of left-rear tire.
6. Install left-rear tire.
