Commander 4WD V6-3.7L VIN K (2007)
10. Using a utility knife or equivalent, cut off the trim tab on the back side of the upper "B" pillar cover (Figure 5).
11. Install the "B" pillar bracket as shown in Figure 6.
12. Install the upper "B" pillar cover onto the vehicle "B" pillar.
13. Install the original upper "B" pillar cover retaining screw.
CAUTION:
Be sure that the "B" pillar bracket is in place before installing the screw.
14. Install the plastic "RS" screw cover (Figure 1).
15. Install the ATL "D" ring pivot bolt and plastic spacer (Figure 2).
Tighten pivot bolt to 29 ft. lbs (39 N.m).
