Commander 4WD V6-3.7L VIN K (2007)
1. Position the second row center seat belt and retractor unit through the opening in the front upper right corner of the seat back frame (2). Be certain
to engage the tab on the retractor into the slot (1) in the back of the seat back frame.
2. Install and tighten the screw (3) into the back of the center seat back frame that secures the retractor. Tighten the screw to 50 Nm (37 ft. lbs.).
3. Pull the foam seat back cushion (2) away from the front upper right corner of the center seat back frame far enough to position the retractor shield
(3) to the seat back frame.
4. Install and tighten the two screws (1) that secure the retractor shield to the seat back frame. Tighten the screws to 2 Nm (18 in. lbs.).
5. Reinstall the trim onto the trim onto the back and the top of the second row center seat back frame.
6. Slide the seat belt webbing (3) through the slot (4) in the seat belt escutcheon (2) and position the escutcheon to the top of the second row center
seat back (1).
7. Using hand pressure, press the escutcheon firmly and evenly down onto the top of the seat back until the barrel clips are fully engaged.
