Commander 4WD V6-3.7L VIN K (2007)
Battery Cable: Service and Repair
Battery Cables - Installation
INSTALLATION
NOTE: Both the battery negative cable and the battery positive cable are serviced in the battery wire harness. If either battery cable is damaged or
inoperative, the battery wire harness assembly must be replaced.
1. Clean and inspect the battery cable terminal clamps and the battery terminal posts.
2. Position the battery wire harness assembly (10) into the vehicle.
3. Raise the vehicle on a hoist.
4. Install the battery wire harness retaining clips (7) & (9) to the engine.
5. Reconnect the battery wire harness connector (2) to the connector receptacle on the starter solenoid.
6. Install the battery positive cable eyelet terminal (3) onto the B(+) terminal stud on the starter solenoid.
7. Install and tighten the nut (4) that secures the battery positive cable eyelet terminal (3) to the B(+) terminal stud on the starter solenoid. Tighten the
nut to 11 Nm (95 in. lbs.).
8. Install and tighten the bolt (5) that secures the battery negative cable ground eyelet terminal (6) to the engine block (10). Tighten the bolt to 11 Nm
(95 in. lbs.).
9. Lower the vehicle.
