Commander 4WD V6-3.7L VIN K (2007)
9. Install the knuckles (1) and install the halfshaft nut (3). (if equipped)
10. Tighten the halfshaft nut (3) to 251 Nm (185 ft. lbs.). (if equipped)
11. Install the lower ball joint into the knuckle.
12. Install the lower ball joint nut (4) and tighten the nut to 81 Nm (60 ft. lbs.).
13. Install the upper ball joint into the knuckle.
14. Install the upper ball joint nut (2). Tighten the nut to 81 Nm (60 ft. lbs.).
15. Install the outer tie rod end into the steering knuckle.
16. Tighten the ball stud nut (5) on the ball stud to 75 Nm (55 ft. lbs.).
17. Connect the speed sensor electrical connectors (2) and fasten the harness support clips (1) fully.
18. Install the rotors.
19. Check and fill the front differential as necessary.
20. Install the front skid plates.
21. Check and adjust front wheel alignment as necessary.
