Commander 4WD V6-3.7L VIN K (2007)
Shift Cable: Service and Repair
545RFE Automatic Transmission
Removal
REMOVAL
1. Shift transmission into PARK.
2. Raise vehicle.
3. Disengage the gearshift cable (3) eyelet at transmission manual shift lever (2) and pull cable out of the mounting bracket (4).
4. Lower the vehicle.
5. Remove the floor console as necessary to access the shift mechanism and cables.
6. If necessary, remove the bolts holding the shield, covering the gearshift and park lock cables, to the shifter assembly and remove the shield.
7. Remove the gearshift cable (3) from the shift lever pin.
8. Remove the gearshift cable retainer (4) from the notch in the shifter assembly.
9. From under the hood, remove the shift cable grommet from the dash panel.
10. Remove gearshift cable from vehicle.
Installation
INSTALLATION
