Commander 4WD V6-3.7L VIN K (2007)
NOTE: The sleeves and pistons of the overlap regulating valves must not be mixed up.
2. Install all valves and springs from the valve body (1). Check all valves for ease of movement and shavings.
3. Install the screws to hold the side covers to the valve body. Tighten the screws to 4 Nm (35 in.lbs.).
4. Install all valves and springs into the valve housing (2). Check all valves for ease of movement and shavings.
5. Install the screws to hold the side covers to the valve housing. Tighten the screws to 4 Nm (35 in.lbs.).
