Commander 4WD V6-3.7L VIN K (2007)
5. Remove bearings (4) from the cage (1).
6. Rotate cage (1) 30° and slide cage off the inner race (2) and down the shaft (3).
7. Remove spread inner race (1) snap ring (4) and remove race (1) from the shaft (3).
8. Remove boot from the shaft and discard.
9. Clean and inspect housing (1), cage (2), bearings (3), housing snap-ring (4), inner race snap-ring (5) and inner race (6) for wear or damage.
Installation
INSTALLATION
1. Apply a coat of grease supplied with the joint/boot to the C/V joint components before assembling them.
2. Place new clamps on the new boot and slide boot down the shaft.
