Commander 4WD V6-3.7L VIN K (2007)
Wiper Switch: Service and Repair
Installation
INSTALLATION
WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the supplemental restraint system before attempting
any steering wheel, steering column, airbag, seat belt tensioner, impact sensor, or instrument panel component diagnosis or service. Disconnect
and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further
diagnosis or service. This is the only sure way to disable the supplemental restraint system. Failure to take the proper precautions could result
in accidental airbag deployment.
1. Position the right multi-function switch (3) to the back of the Steering Control Module (SCM) and reconnect the switch connector to the SCM.
2. Align the two locating tabs (2) on the SCM with the switch housing.
3. Install and tighten the two screws (1) that secure the switch to the SCM. Tighten the screws to 0.35 Nm (3 in. lbs.).
4. Reinstall the upper and lower shrouds onto the steering column.
5. Reconnect the battery negative cable.
