Commander 4WD V6-3.7L VIN K (2007)
Windshield Washer Reservoir: Service and Repair
Installation
INSTALLATION
1. Position the washer reservoir (1) into the left front fender wheel house from underneath the vehicle.
2. Raise the washer reservoir into position, rotating it as necessary for clearance.
3. Engage the hook tab at the front of the reservoir into the slot in the left front frame rail.
4. Install and tighten the two screws (2) that secure the washer reservoir to the left front frame rail. Tighten the screws to 7 Nm (60 in. lbs.).
NOTE: Be certain to reconnect the front and rear washer hoses to the proper outlet nipples of the washer pump. Failure to properly connect the
hoses will cause the front and rear washer systems to operate incorrectly.
5. Reconnect the front and rear washer hoses to the barbed outlet nipples of the washer pump.
6. Reconnect the headlamp and dash wire harness connectors (2) for the washer pump/motor unit (4) and the washer fluid level switch (3).
7. Reinstall the plastic push-in fasteners that secure the left front wheelhouse splash shield to the inner fender panel and the front fascia.
8. Lower the vehicle.
