Commander 4WD V8-4.7L (2008)
Parking Assist Distance Sensor: Service and Repair
Park Assist Sensor - Removal
Front
FRONT
NOTE: The park assist sensors (3) and the sensor spacers (2) are each available for separate service replacement. The sensor brackets (1) are
bonded and integral to the back side of the front bumper fascia (4).
1. Disconnect and isolate the battery negative cable.
2. Remove the bumper fascia from the front of the vehicle. See: Body and Frame/Bumper/Front Bumper/Front Bumper Cover / Fascia/Service and
Repair/Front Fascia - Removal.
3. From the back of the fascia (4), disconnect the wire harness connector from the park assist sensor (3) connector receptacle.
4. Carefully pry the sensor bracket (1) latch features away from the top and bottom tabs of the sensor far enough to disengage the sensor from the
bracket.
5. Disengage the O-ring spacer (2) from around the circumference of the sensor membrane protrusion.
Rear
REAR
NOTE: The park assist sensors (3) and the sensor spacers (2) are each available for separate service replacement. The sensor brackets (1) are
bonded and integral to the back side of the rear bumper fascia (4).
1. Disconnect and isolate the battery negative cable.
NOTE: The two outboard rear park assist sensors can be accessed for service with the rear bumper fascia installed on the vehicle.
2. For the two inboard rear park assist sensors only, remove the bumper fascia from the rear of the vehicle. See: Body and Frame/Bumper/Rear